BELLOW YOU CAN FIND THE MOST COMMON SHORTCUTS OF THE DWOS v6 SOFTWARE
CTRL + Y and CTRL + Z will allow you to undo and redo the last steps you have made while being in the design mode.
It is available when you are adding or removing material, moving clinical handles, transforming crowns or pontics, etc.
Additionally you can use the small arrows in the respective window as shown on the screenshot.
CTRL + left click on one handle of a connector will allow you to move the whole connector at once on the mesial or distal side.
Left click on one handle of a connector + scrolling the mouse wheel will increase or decrease the current shape of the connector on the mesial or distal side.
CTRL + left click on a handle while transforming the crown will move all handles with the same colour simultaneously.
Moving the margin line handles with the cursor will move the handles in pre-defined steps.
To decrease the distance a handle is moved keep the CTRL key pressed. To increase the distance a handle is moved keep the SHIFT key pressed.
When using scan import or the arch scan station the area of interest (the green line)
can be turned in 90 degrees steps by pressing the left or right cursor.
By left clicking one of the green handles at the end of the green line and scrolling the mouse wheel at the same time the curve of the green line can be adapted.
If the transform function of a crown is not applied on the correct axis (due to scan import, tilted model, etc.) the axis can be reset by pressing CTRL + P.
When using the waxing tools to add/remove/smooth or morph material the radius of the brush can be changed by left clicking and scrolling the mouse wheel at the same time.
Any value can easily be changed by clicking into the field and simply turning the mouse wheel.
While designing a custom abutment the combination of keeping the CTRL key pressed,
left clicking on one of the red handles and turning the mouse wheel at the same time will slim the area or make it bulkier.
